VISO S 28

VISO 28

Motion Sensor:
Multifunctional sensor module
as MASTER Application Controller.

Sensor unit for DALI-2 lighting control systems with four operation modes: motion-controlled, motion-controlled with constant light regulation, constant light regulation and light control (4 thresholds).

INSTALLATION

VISO 28 | Motion sensor | MASTER Application Controller

Despite its compact size, the sensor offers a large detection range and can be integrated into any DALI-2 lighting control system. In addition to controlling light scenes through motion detection and light intensity measurement, the VISO 28 can also be used for light-level controlled regulation of blinds or shading systems.

Like all components of the SYSTEM DOT 28, the new motion and daylight sensor VISO 28 can be integrated flush and frameless into any ceiling material. With its outer diameter of just 28 mm, the motion and daylight sensor blends discreetly into its surroundings. Available in 2 colours and 2 basic configurations.
- MASTER Application Controller
- Instance Mode


Art.Nr. Modul
218000 VISO 28 Black | MASTER Application Controller | Sensor Unit for DALI-2 lighting control systems | Ø7m detection range, section at 3m room height | IP40 | Ø28 x 26mm | available from May 2025
218050 VISO 28 White | MASTER Application Controller | Sensor Unit for DALI-2 lighting control systems | Ø7m detection range, section at 3m room height | IP40 | Ø28 x 26mm | available from May 2025
See VISO S 28 Instance Mode

Add the following specifications to your order:

Art.Nr. Supplementary articles
218800 DALI PS2 30mA | DALI power supply unit 30mA for VISO 28 MASTER Application Controller, if no DALI power supply is available
218810 DALI-2 USB | Interface module between a DALI bus and the DALI Cockpit configuration software for programming the VISO 28 sensor MASTER Application Controller | incl. 30mA power supply
218020 SUPPORT | for specific time adjustment (modification of factory setting*) in the MASTER Application Controller


Werkseinstellung VISO 28

1. Fade in Time - dimming up to 1st light level
A. holt time 1st light level: ___min
3. Fade Time - dim down
B. lowering value 2nd light level: ___%
C. hold time 2nd light level: ___min
5. Fade OutTime - dimming down to OFF
P. Retrigger
7. OFF


*factory setting:
A. hold time 1st light level: 12min
B. lowering value 2nd light level: 20%
C. hold time 2nd light level: 3min

Detection range VISO 28


Erfassungsbereich VISO 28

motion detection area:
X-Y cross section at 3m mounting height – following applies to the calculation of the detection radius for alternative mounting heights:
Radius = mounting height * 1,42
Please note that the detection range may change when using plastic installation modules of the DOT 28 system.