1. Take care of keeping clean and undamaged the recess of the luminaire during the whole process.
2. Screw the luminaire modul on the same substructre as the plasterboard (12.5mm).
3. For double plating take care of an adequate recess and the first plater board plating.
4. Put a fabric tape into the spatula border intended therefore.
5. Finish the joints cleanly and neatly and use a filler which is elastic enough.
6. Ground and apply the paint on the luminaire. Best use a small structured roll.
The lamp is not suitable for outside. Do not use the lamp on coarsegrained plaster.
Provide at least 1dm³ of airspace for the LED heat sink!
