1. Make cutout of the specified size in the plasterboard
and prepare substructure so that the installation module can be
screwed well into the plasterboard ceiling.
2. Connect supply cables to the module.
Ensure correct wiring if there are more than one modules
(series circuit). We recommend wiring each VERSA module
individually in order to facilitate possible troubleshooting later.
The number of luminaires (3 LEDs per VERSA) depends on the
capacity of the led-driver. Please observe specifications on
devices or in our planning documents.
3. Carefully screw plaster module into prepared opening. Always
pay attention to VERSA‘s delicate edges, especially on the
recesses.
4. IMPORTANT TEST OPERATION: Put LED into LED mounting and turn clockwise
by approx 90° until it sits securely. For this installation we
recommend the assembly pliers of our DOT 28 System 168101.
This way you test the correct wiring within the system including
the led-driver. CAUTION! HOT PLUG! Remove the LED after
successful testing if the insides of the openings will be painted.
5. Adding fabric tape, fill the joints diligently. Make sure
to fill only the joints and leave the three-dimensional elements
intact.
Prime and paint the plaster module with
the ceiling paint. The insides of the round recesses may also
be carefully painted. The plaster modules are not suitable for
coarse plaster!
6. Put desired LED insert into LED mounting and turn clockwise
by approx. 90° until it sits securely. We recommend using
the DOT 28 System mounting pliers 168101. CAUTION!
HOT PLUG! The number of luminaires (3 LEDs per VERSA)
depends on the capacity of the led-driver. Please observe
specifications on devices or in our planning documents.
CAUTION: Please check individually with your contractor if you want to
use coarse plaster, clay plaster, or acoustic plaster.
Plaster modules are brittle and may break easily. Take particular
care of the module’s very delicate recesses.
Reserve enough air space for cooling element. Observe minimum
installation depth for module. The luminaire must not be covered
with insulation material, a steam brake, fleece or film!
