1.
Cut recess for LED mount into desired board according to drawing.
2.
On back of module, set desired board thickness using the three setting screws. Observe fixed measurements, shown in red in drawing.
3. Mount module on board form behind. To do so, use holes next to setting screws. Attention: Cooling plate must not be deformed!
4.
Establish module’s electrical connection. Make sure to observe serial cabling (series connection) and maximum current feed.
5.
Carry out continuity test to check if electric circuit is closed. Then remove wire link.
CAUTION: Airspace and maximum current feed must be complied with.
6.
Put desired LED insert flush into LED mounting and turn
clockwise by approx. 90° until it sits securely. You may use the
DOT 28 System mounting pliers to do so. CAUTION: HOT PLUG! Every luminaire ist tested in live operation before shipping.
