1. Connect the luminaire correctly to the feed of the LED driver (constant feed). The LED driver must be disconnected from the power supply! It is essential to ensure that the constant current source has been disconnected from the mains for at least 10-15 seconds before lights are connected!
2. We recommend using the circlip pliers 10-25mm (art. no.: 168101) to mount the light in the best
possible way. Before inserting the light into the installation module, make sure that the hole is free of dirt. Insert the working tips into the mounting holes and press the circlip pliers together with a firm grip. Insert the light into the installation module as far as it will go and carefully turn it 90° to the right. Once back at the stop, pull the light downwards until it is flush with the ceiling. When installing the light completely, make sure that the circlip pliers are held firmly to prevent slipping and possible damage to the cover ring.
To de-install, hold the light with the circlip pliers again with a firm grip and push it into the ceiling as far as it will go. Turn the light 90° to the left and carefully pull it downwards and out of the
ceiling.
CAUTION: Provide enough airspace for the cooling element. Observe minimum installation depth. Do not cover with insulation material, steam brake, fleece or film!
For DOT 28 CONE and DOT 28 POWER CONE, the luminaire is always supplied with an integrated lifting bracket.This is used to pull the luminaire up to the ceiling.
